It is a challenge to do crown molding and pot lighting installation but with the right knowledge and skills, you will be able to do it with ease. How can you achieve a beautiful crown molding? For a more dramatic crown, we will teach you how to install a crown molding that has the combination of standard crown molding with two-pieces of base trim. It is a good idea measuring the length of the wall for the crown molding so you can buy pieces that are long enough to span each wall, and to prevent scarfing pieces together. If you are planning to use a light-colored stain choose pieces of similar tone. You can choose to install your crown molding using a brad nailer and miter saw for better results and faster work.
For a more elegant and larger look, crown molding can be combined with other trim, offering dozens of possibilities such as combining more pieces of contrasting woods for a two-tone effect. Built-up crown offers a lot of benefits such as eliminating nailing frustrations. In order for you to know where to drive the nails, you can use a chalk to put markings and lines, although professional carpenters put lines and marks right on the ceilings and wall, and just hide them with paint later on. An easier method is sticking bands of 2 inches wide masking tape to the ceiling and walls. If you are planning to paint the ceiling and walls, you have to wait a couple of weeks before applying the tape, otherwise, it won’t stick well. Now, you can install the trim over the masking tape, and leave it in place to protect your ceiling and walls when you paint or apply a finishing coat. When it comes to the actual trim placement, add the piece to the right next to the first piece in place, and work around the room in that direction, so in that way, you will make most of your 45-degree cuts using a miter saw. By doing so, your molding job becomes easier, and you can also use construction adhesive on the rail (even those areas where you can nail into ceiling joists and studs) for you to use just enough nails, holding the trim into its place until the adhesive sets, with fewer nail holes to fill.
The corners of your room may not be a perfect square, so you have to use test pieces in order to find the right angle for each corner, and you need to miter the ceiling rails inside and outside. Coping your wall rails is like coping the crown, wherein they are coped at inside corners and mitered at outside corners. It can be daunting and confusing having a DIY crown molding and pot installation project, so do not hesitate to contact a professional carpenter to help you. Visit our website and check the best crown molding and pot installation companies today!What Research About Moulding Can Teach You